|
|
|
|
|
| | Rust-Convert is a one component water base film forming material that converts tightly adherent rust into a non-rusting black film. | | |
| auto rust repair, decorative gates, guard rails, machinery, garden tools, outdoor signs and dishes support, frame work, pipes and tanks exterior, … and in all surfaces not accessible for blast cleaning.
Notes:
-There must be rust present on the surface to be primed or the rust conversion process will not occur. If Rust-Convert turns black, usually within 30 minutes, the conversion process was successful and a topcoat can be applied in 4 to 6 hours.
-If Rust-Convert does not turn black, allow a minimum of 24 hours dry time before topcoating may occur.
-Not recommended for permanent immersion in fresh or salt water.
-Do not use zinc-rich primers over Rust-Convert.
-Staining may appear if water based or light coloured primers or top-coats are used. | | |
| • One coat application is sufficient to convert adherent rust into a non-rusting black film and to provide corrosion protection against new rust forming, but for best results it is recommended to apply two thin coats.
• Easy to use.
• May be applied to damp but not wet surfaces.
• Provides a tough and flexible film.
• May be topcoated with latex, alkyd, urethane or epoxy finishes.
| | |
| | • Method of Application : | Brush, roller, or dipping. | | • Thinner / Cleaner : | Do not thin. Clean applying tools by water. | | • Application Temperature : | 5-30?C. |
| | |
| | • Number of Coats : | 1- 2, apply the 2nd coat within 20-30 minutes in a cross direction to the previous one. Allow to dry for 24 hrs. | | • Packaging : | 1L in plastic bottle. |
| | |
| | Remove loose rust, failing paint, dust, dirt, etc.; If there is oil or grease on the surface, remove these contaminates by washing the surface. | | |
| | | |
| -Rust-Convert has to be kept in a cool and well-ventilated place, protected from heat and direct sunlight.
-Shelf life is at least one year from packing date in unopened original containers at 10 to 40°C. Containers should be kept tightly closed.
Safety:
-Corrosive, contains phosphoric acid.
-Well-ventilated conditions should be provided during application.
-Do not breathe or inhale mist.
-Wear air mask and avoid skin or eye contact | |
|
|
|
|
information in this data sheet and in all our data sheets are given to the best
of our knowledge based on laboratory testing and practical experience. Final results
depend on following instructions and on consumer skill. Our responsibility is limited
to providing products that Conform to samples and specimens provided by us. Due
to technical needs, we reserve the right to change any given specification without
notice.
|
|
|
