|
|
|
|
|
| | A roller textured easy-to-use acrylic paint, ideal for hiding imperfections on most sound, dry and concrete walls and ceilings | | |
| Morocco is used as a highly decorative interior coating on concrete, cement, lightweight concrete, cement board, and gypsum board,…etc. Typical uses are in all types of residential and
commercial buildings as a low cost alternative to finishing materials such as stone and brickwork
| | |
| • Easily used
• Good adhesion to concrete substrates.
• Short drying time, reducing over-coating time considerably
• Excellent resistance to dust and dirt, surfaces easily and rapidly cleaned
• Ideal for covering minor defects and irregularities in the substrate
• Economical, easy to apply and low cost maintenance. | | |
| | • Method of Application : | roller, or airless spray | | • Mixing : | Stir well before application in order to ensure that a uniform consistency is achieved | | • Thinner / Cleaner : | In general, there is no need to dilute, but if required 20- 15% max by volume of water is added when application occurs by roller. Clean applying tools immediately after application is completed by water. | | • Application Temperature : | 10-40 °c |
| | |
| | • Color : | White or upon request | | • Volume Solids : | 43.6% (ASTM-D2697) | | • VOC : | 10 g/L (ASTM-D3960) | | • Flexibility : | Good | | • Adhesion : | Good | | • Recommended film thickness : | 100-200 microns dry | | • Theoretical spreading rate : | 4.4 m²/L at 100 microns dry | | • Specific gravity : | 1.6 kg/L (ASTM-D1475) | | • Water resistance : | Good | | • Number of Coats : | 1-2 | | • Packaging : | 18 kg in a plastic can |
| | |
|
Coating performance is, in general, proportional to the degree of surface preparation.
Surface must be clean,
undamaged and free of oil, grease, and other contaminants prior to coating.
It is recommended to apply Morocco on primed surfaces.
Priming: Prepare surface in accordance with application instructions for the suitable primer
being used sealer.
The primer and undercoat should be left to achieve a tack free condition prior to applying
Morocco.
Be sure primer and undercoat are clean, dry, and free of oil grease and other contaminants
When Morocco is applied.
It is possiple to recoat over.
| | |
| | • Dry to Touch : | 30 min. (ASTM-D1640) | | • Dry to Handle : | 2 hour "minimum recoating time" (ASTM-D1640) | | • Note : | Drying time can be affected by many factors such as temperature, ventilation, and coat thickness. Higher temperature will shorten the drying time. |
| | |
| Morocco must not be allowed to come into contact with metals that are likely to corrode.
Containers must be kept tightly closed. Exposure to strong heat and frost must be avoided.
Shelf life is two years from packing date in unopened original containers at 10 to 40°C.
Containers should be kept tightly closed.
| | |
| | |
|
|
|
|
information in this data sheet and in all our data sheets are given to the best
of our knowledge based on laboratory testing and practical experience. Final results
depend on following instructions and on consumer skill. Our responsibility is limited
to providing products that Conform to samples and specimens provided by us. Due
to technical needs, we reserve the right to change any given specification without
notice.
|
|
|
