|
|
|
|
|
| | Synthetic lacquer based on alkyd. | | |
| | As a multi purpose clear finishing coat recommended mainly for furniture. Higher durability and faster drying can be obtained by adding ALDAHAB 205 drier. | | |
| • Provides a smooth and flexible surface for wooden substrates.
• Good gloss aspect.
• High resistance to mechanical wear, weathering, and UV.
• Higher durability and faster drying can be obtained by adding ALDAHAB 205 drier.
• Low cost.
| | |
| | • Method of Application : | Conventional spray. | | • Mixing Ratio : | (by volume)
4 to 1 (A to B) “if ALDAHAB 205 drier is used” | | • Mixing : | Stir well before application in order to ensure that a uniform consistency is achieved. | | • Pot life : | 4 hours “if ALDAHAB 205 drier is used” | | • Thinner / Cleaner : | S205 is used for thinning and cleaning. Mixing ratio with S205 depends mainly on temperature.
At 20°C, conventional spray application will need approx. 1.56 litre thinner S205 per gallon ALDAHAB 205 Lacquer. | | • Note : | When recoating a special attention should be given toward drying times. |
| | |
| | • Component B : | ALDAHAB 205 drier is used if higher durability and faster drying are required | | • Color : | Transparent | | • Volume Solids : | 36% (ASTM-D2697) | | • Flexibility : | Good | | • Recommended film thickness : | 30 microns “dry” | | • Theoretical spreading rate : | 12 m²/L at 30 microns “dry” | | • Specific gravity : | 0.91 Kg/L (ASTM-D1475) | | • Water resistance : | Good | | • Abrasian Resistance : | Good | | • Number of Coats : | 1-2 | | • Packaging : | Component A 3.6 L or 0.9 L in metal can
Component B (If required) 0.9 L or 0.225 L in metal can |
| | |
| Coating performance is, in general, proportional to the degree of surface preparation. Surface must be clean, dry, and free of dust and other contaminants prior to coating.
It is recommended to apply ALDAHAB 205 Lacquer on well-sanded bare wood or over OMEGAN sealer (2K) or NCL sealer. | | |
| | • Dry to Touch : | 30 minutes (ASTM-D1640). | | • Dry to Handle : | 8 hours or “4 hours if ALDAHAB 205 drier is used” (minimum recoat time); (ASTM-D1640). | | • Note : | Drying times can be affected by many factors such as temperature, ventilation and coat thickness.
Higher temperatures will shorten the drying times. |
| | |
| ALDAHAB 205 Lacquer has to be kept in a cool and well-ventilated place, protected from heat and direct sunlight. ALDAHAB 205 Lacquer is classified under high flammable materials.
Shelf life is 18 months from packing date in unopened original containers at 5 to 40°C. Containers should be kept tightly closed.
Safety
Well-ventilated conditions should be provided during application.
Do not breathe or inhale mist.
Wear air-mask and avoid skin or eye contact. | |
|
|
|
|
information in this data sheet and in all our data sheets are given to the best
of our knowledge based on laboratory testing and practical experience. Final results
depend on following instructions and on consumer skill. Our responsibility is limited
to providing products that Conform to samples and specimens provided by us. Due
to technical needs, we reserve the right to change any given specification without
notice.
|
|
|
