|
|
|
|
|
| | One component nitrocellulose surfacer. | | |
| | Used mainly as a surfacer over primed, filled, and leveled metal surfaces for auto repair, and vehicles. AC surfacer can also be used for furniture | | |
| • Excellent smootheness (will lead to a low absorbent substrate).
• Short drying times, reducing recoating times considerably.
• Good adhesion.
• Reduces absorption of finishing coat and improves its hiding power.
| | |
| | • Method of Application : | Conventional spray. | | • Mixing Ratio : | | | • Cleaner : | Thinner S501 or S502 are used for thinning or cleaning. Mixing ratio with thinner depends mainly on temperature. | | • Note : | Stirr well before mixing. |
| | |
| | • Color : | White, gray, black | | • Flexibility : | Very good | | • Adhesion : | Good | | • Recommended film thickness : | 50 microns “dry, after sanding” | | • Number of Coats : | 2-3 | | • Packaging : | 3.6 L or 0.9 L in metal can. |
| | |
| • Suitable Substrates: In general, AC surfacer is recommended to be applied directly over putties as an intermediate coat.
• Surface Preparation:
1. Fill surfaces with suitable putty.
2. Shape and sand filler using 180-240 and 320-400 grit treated sandpaper respectively.
3. Remove sanding residue using air pressure then clean by thinner (S100 or S501).
4. Apply 2-3 coats of AC Surfacer immediately after surface preparation.
Note: If needed, for best leveling, apply a AC putty then surface again with AC Surfacer.
• Recoating: In general, fine sanded AC-Surfacer is considered to be a universal intermediate coat. It can be topcoated by almost all kinds of topcoats.
Note: It is recommended to apply SRT Primer/Surfacer (AC2) instead of AC surfacer when finishing is achieved by 2k-coatings “such as SRT Coat or SRT Clearcoat” at 60-80°C inside spraying booths.
| | |
| | • Dry to Touch : | 10 minutes | | • Dry to Handle : | 30 minutes | | • Dry to Sand : | 2 hours “minimum recoat time” | | • Note : | Drying times can be affected by many factors such as temperature, ventilation and coat thickness. Higher temperatures will shorten the drying times. |
| | |
| • AC surfacer is classified under high flammable materials. Containers must be kept tightly closed in a cool and well-ventilated place, protected from heat and direct sunlight.
• Shelf life is three years from packing date in unopened original containers at 10 to 40°C.
Safety:
• Well-ventilated conditions should be provided during application.
• Do not breathe or inhale mist
• Wear air-mask and avoid skin or eye contact.
| |
|
|
|
|
information in this data sheet and in all our data sheets are given to the best
of our knowledge based on laboratory testing and practical experience. Final results
depend on following instructions and on consumer skill. Our responsibility is limited
to providing products that Conform to samples and specimens provided by us. Due
to technical needs, we reserve the right to change any given specification without
notice.
|
|
|
